Hp Hitachi Dynamic Link Manager Software Instrukcja Użytkownika Strona 397

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 396
4. HDLM Operation
373
Legend:
a: Host ID (host port number)
b: Channel number (bus number)
c: Target ID
d: Lun (host LU number)
n: host port number
driver-name:
qlaxxxx (driver name in use)
Example entries are shown below.
When adding a device by using a QLogic HBA driver in Red Hat Enterprise
Linux AS4/ES4:
# echo "scsi-qlascan" > /proc/scsi/qla2200/1
# cat /proc/scsi/qla2200/1
# echo "scsi add-single-device 1 0 1 1" > /proc/scsi/scsi
4. Execute the HDLM-configuration definition utility (dlmcfgmgr -r).
Based on the SCSI device created in step 3, an HDLM device for the path
configured in step 1 is added.
The following is an example of executing the
dlmcfgmgr utility:
# /sbin/dlmcfgmgr -r
5. Restart the host on which the HDLM is installed.
If you performed step 3 and step 4, the host does not have to be restarted. Go to
step 6.
While restarting, the HDLM device mapped with the path configured in the above
step 1 is added automatically.
6. Refer to
/var/opt/DynamicLinkManager/log/dlmcfgmgr1.log or
execute the
dlmcfgmgr utility (dlmcfgmgr -v) to check if an LU was created
with a new HDLM device name.
Deleting a device
(for FC-SAN
environments)
# dlmcfgmgr -o logical-device-file-name-of-the-relevant-HDLM-device
# echo "scsi remove-single-device
a b c d" > /proc/scsi/scsi
# dlmcfgmgr -i logical-device-file-name-of-the-relevant-HDLM-device
Deleting a device
(for IP-SAN
environments)
# echo "scsi remove-single-device a b c d" > /proc/scsi/scsi
Operation Command
Przeglądanie stron 396
1 2 ... 392 393 394 395 396 397 398 399 400 401 402 ... 745 746

Komentarze do niniejszej Instrukcji

Brak uwag