Hp Tape Library Interface Manager Software Instrukcja Użytkownika Pobierz pdf (Strona 38)

38 Management Operations Chapter 3

Configuration Using the Telnet Interface

Overview

■ Accessing Telnet on page 38

■ Changing the Administration Password Using Telnet on page 40

■ Changing the Clock Setting Using Telnet on page 40

■ Changing the Ethernet Configuration Using Telnet on page 42

■ Changing the Fibre Channel Address Modes Using Telnet on page 42

■ Placing a Fibre Channel Interface Card Off-Line Using Telnet on page 45

■ Placing a Fibre Channel Interface Card On-Line Using Telnet on page 47

■ Installing a New Fibre Channel Interface Card Using Telnet on page 49

■ Changing a Fibre Channel Interface Card Configuration Using Telnet on

page 51

■ Choosing Which Card to be Configured on page 51

■ Factory Defaults for the Fibre Channel Interface Card on page 52

Accessing Telnet

To access Telnet, do the following:

1. Apply power to the connected SCSI and Fibre Channel devices

2. After all of the devices have gone through their power-up routines, boot up

the IM.

3. Power on the host computer.

From most Windows 9x and NT systems, users can start a Telnet session from

the DOS (or Command) prompt using the following steps:

1. From the Windows Start menu, open the DOS (or Command) prompt

window.

2. At the ‘>’ prompt, enter the following command:

Telnet <IP address>

where <IP address> is the IP address of the IM. This will start a Telnet

session window for the IM.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 137 138

Brak uwag

Hp Tape Library Interface Manager Software Instrukcja Użytkownika Strona 38