HP EliteDesk 800 G4 Base Model Small Form Factor PC Instrukcja Użytkownika Pobierz pdf (Strona 44)

Installing a 3.5-inch hard drive

NOTE: There are two 3.5-inch hard drive bays. The procedure for installing a 3.5-inch hard drive is the same

for each drive bay.

1. Prepare the computer for disassembly (Preparation for disassembly on page 17).

2. Remove the access panel (Access panel on page 18).

3. Install mounting screws on the sides of the hard drive using standard 6-32 silver-and-blue mounting

screws.

NOTE: If replacing a 3.5-inch hard drive, transfer the mounting screws from the old hard drive to the

new hard drive.

If you are adding a second 3.5-inch hard drive, you can purchase extra mounting screws from HP.

●

Install four silver-and-blue 6-32 mounting screws (two on each side of the drive).

●

You can also install a 2.5-inch hard drive into a 3.5-inch drive bay using an adapter bracket similar

to the example shown below.

–

Slide the 2.5-inch drive into the 3.5-inch adapter bracket.

36 Chapter 4 Removal and replacement procedures

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 143 144

Brak uwag

HP EliteDesk 800 G4 Base Model Small Form Factor PC Instrukcja Użytkownika Strona 44