Hp Netserver L Server series Instrukcja Użytkownika Pobierz pdf (Strona 32)

Chapter 5 Installing Additional Memory

Figure 5-4. Inserting DIMM Into Memory Board

6. Repeat step 5 to install all of the DIMMs for your memory configuration.

7. Reinstall the memory boards. Memory A and Memory B need to be

identical, so they are interchangeable in their sockets.

8. Close the memory cage cover and tighten the screw.

9. Replace the cover.

10. Restore electrical connections.

Installing Additional Memory in the LH 4r

NOTE How to change the memory in a racked NetServer depends on

how high (or low) in the rack it is mounted. If there is room

underneath the extended NetServer to reach up from below

into the memory cage, the System board assembly can remain

inside the NetServer. These instructions assume you need to

remove the System board assembly.

If you can reach the memory cage, proceed as for the LH 4.

1. Turn OFF the NetServer and remove all cables from the rear of the

NetServer. Pull both power plugs out.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 125 126

Brak uwag

Hp Netserver L Server series Instrukcja Użytkownika Strona 32