Hp ProLiant DL320e Gen8 Server Instrukcja Użytkownika Pobierz pdf (Strona 19)

Operations 19

Disconnect each power cord from the power source.

b. Disconnect each power cord from the server.

3. Do one of the following:

o Extend the server from the rack (on page 16).

o Remove the server from the rack (on page 17).

4. Open the access panel latch, slide the access panel to the rear of the chassis, and then remove the

access panel.

If the access panel latch is locked, use a T-15 Torx screwdriver to unlock the latch.

Install the access panel

1. Place the access panel on top of the server with the locking latch open. Allow the panel to extend past

the rear of the server by approximately 1.25 cm (0.5 inch).

2. Press the locking latch. The access panel slides to a closed position.

3. Use a T-15 Torx screwdriver to tighten the security screw on the locking latch.

Remove the air baffle

CAUTION: For proper cooling, do not operate the server without the access panel, baffles,

expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize

the amount of time the access panel is open.

To remove the component:

1. Power down the server (on page 16).

2. Remove all power:

a. Disconnect each power cord from the power source.

b. Disconnect each power cord from the server.

3. Do one of the following:

o Extend the server from the rack (on page 16).

o Remove the server from the rack (on page 17).

4. Remove the access panel (on page 18).

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 95 96

Brak uwag

Hp ProLiant DL320e Gen8 Server Instrukcja Użytkownika Strona 19