Hp ProLiant DL360e Gen8 Server Instrukcja Użytkownika Pobierz pdf (Strona 19)

Operations 19

Disconnect each power cord from the power source.

b. Disconnect each power cord from the server.

3. Do one of the following:

o Extend the server from the rack (on page 16).

o Remove the server from the rack (on page 17).

4. Open the access panel latch, slide the access panel to the rear of the chassis, and then remove the

access panel.

If the access panel latch is locked, use a T-15 Torx screwdriver to unlock the latch.

Install the access panel

1. Place the access panel on top of the server with the access panel latch open. Allow the panel to extend

past the rear of the server by approximately 1.25 cm (0.5 inch).

2. Close the access panel latch. The access panel slides to a closed position.

3. Use a T-15 Torx screwdriver to tighten the access panel latch screw.

Remove the PCI riser cage

CAUTION: To prevent damage to the server or expansion boards, power down the server, and

disconnect all power cords before removing or installing the PCI riser cage.

1. Power down the server (on page 16).

2. Remove all power:

a. Disconnect each power cord from the power source.

b. Disconnect each power cord from the server.

3. Do one of the following:

o Extend the server from the rack (on page 16).

o Remove the server from the rack (on page 17).

4. Remove the access panel (on page 18).

5. Disconnect all cables connected to any existing expansion board.

6. Lift the release tabs, and then rotate them 180° counterclockwise.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 113 114

Brak uwag

Hp ProLiant DL360e Gen8 Server Instrukcja Użytkownika Strona 19