Hp ProLiant DL360e Gen8 Server Instrukcja Użytkownika Pobierz pdf (Strona 34)

Hardware options installation 34

10.

Install the access panel (on page 19).

11. Install the server into the rack ("Installing the server into the rack" on page 26).

12. Install the drives ("Installing a hot-plug drive" on page 31).

CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless

all bays are populated with either a component or a blank.

13. Power up the server (on page 16).

Mini-SAS cable option

The Mini-SAS cables in this option kit support the following drive configurations:

Drive configuration HP Smart Array RAID Controller Expansion slot Mini-SAS cable

Four-bay LFF

H220 or P420 Full height or low

profile

800 mm

Four-bay LFF

H222 or P222 Full height or low

profile

890 mm

Eight-bay SFF

P822 Full height 615 mm and 800 mm

Eight-bay SFF

H220 or P420 Low profile 615 mm and 800 mm

To connect the cable option:

1. Power down the server (on page 16).

2. Remove all power:

a. Disconnect each power cord from the power source.

b. Disconnect each power cord from the server.

3. Do one of the following:

o Extend the server from the rack (on page 16).

o Remove the server from the rack (on page 17).

4. Remove the access panel (on page 18).

5. Remove the PCI riser cage (on page 19).

6. Install the storage controller ("Installing a storage controller" on page 37).

7. Connect the common end of the Mini-SAS cable to the controller option.

8. Install the PCI riser cage (on page 20).

9. Route the Mini-SAS cable along the side of the system board towards the front chassis, and then connect

the cable to the drive backplane.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 113 114

Brak uwag

Hp ProLiant DL360e Gen8 Server Instrukcja Użytkownika Strona 34