Hp ProLiant DL360e Gen8 Server Instrukcja Użytkownika Pobierz pdf (Strona 53)

Hardware options installation 53

• In multiprocessor configurations, each processor must have a valid Lockstep memory mode

configuration.

• In multiprocessor configurations, each processor may have a different valid Lockstep memory mode

configuration.

Population order

For Lockstep memory mode configurations with a single processor or multiple processors, populate the DIMM

slots in the following order:

• First: B and C

• Last: E and F

Do not populate the DIMM slots A and D.

After installing the DIMMs, to configure memory protection mode, use RBSU ("HP ROM-Based Setup Utility"

on page 81).

Installing a DIMM

1. Power down the server (on page 16).

2. Remove all power:

a. Disconnect each power cord from the power source.

b. Disconnect each power cord from the server.

3. Do one of the following:

o Extend the server from the rack (on page 16).

o Remove the server from the rack (on page 17).

4. Remove the access panel (on page 18).

5. Open the DIMM slot latches.

6. Install the DIMM.

7. Install the access panel (on page 19).

8. Install the server into the rack ("Installing the server into the rack" on page 26).

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 113 114

Brak uwag

Hp ProLiant DL360e Gen8 Server Instrukcja Użytkownika Strona 53