HP 100BaseT Podręcznik Użytkownika Strona 64

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 63
HP 100Base-T Hubs Installation and Reference Guide
Configuring the System 4-5
Configuring Your System
You can configure the HP 100Base-T Hubs using the VT-100
console interface.
On-board configuration requires a terminal or a computer
running a terminal emulation program as your working
platform. There are three valid connection types to the hub:
Out of band connection
The workstation, normally within the vicinity of the hub, is
directly connected to the Console Port on the HP 100Base-T
Hub.
Telnet connection
The workstation is connected to a remote Hub-12TXM via a
networked Telnet connection.
Modem connection
The workstation is connected to a remote Hub-12TXM hub
via modems.
The physical setup and connections required for on-board
configuration are described in detail under
Direct Connection,
Network Connection and Remote Connection in this chapter. To
open the HP 100Base-T Hubs VT-100 console interface, do the
following:
1. Activate an HP 100Base-T Hub VT-100 console interface
from a local console, via Telnet, or via modem connection as
described below.
From a local console -
When connecting a PC to the hub, use a VT-100 terminal
emulation package to connect to the specific Com port that is
attached to the hub. Configure the connection for 9600 baud,
8 data bits, no parity bits, 1 stop bit, and no flow control.
Then press Enter.
Przeglądanie stron 63
1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 156 157

Komentarze do niniejszej Instrukcji

Brak uwag