HP VMA-series Memory Arrays Podręcznik Użytkownika Pobierz pdf (Strona 26)

26 HP VMA SAN Gateway Installation and Configuration Guide AM456-9025A

The fastest way to configure a master or standalone HP VMA SAN Gateway node is with the setup

configuration wizard.

Note: Interface bonding and cluster VLAN configuration are not included in the configuration

wizard setup. For initial cluster setup, or for single-Ethernet cable to Gateway configurations, you

can specify the eth1 interface as the “Public interface name” and “Cluster interface name” in the

wizard. Then configuration of the interface bonding and VLAN using the CLI will be done in the

Redundant Gateway Pairing Process Guide.

To configure the master or standalone SAN Gateway node, do the following:

1. Log in to the SAN Gateway as admin, as described in Logging in to the SAN Gateway on page

22.

2. The configuration wizard prompts you for an initial configuration of the HP VMA SAN

Gateway. Enter Ye s (the first letter must be capitalized).

You are prompted to answer a series of configuration questions. The responses given for each

question will configure the initial HP VMA SAN Gateway, which becomes the master node.

3. After the first question, enter Yes .

Entering Yes defines the current HP VMA SAN Gateway as the master node, whether for a

single node cluster (standalone) or a redundant gateway pair. For information on configuring a

redundant gateway pair, see the

Redundant Gateway Pairing Process Guide at http://www.hp.com/

go/vma-docs.

Do you want to use the wizard for initial configuration? Yes

Step 1: Configure as master/stand-alone? [yes]

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 82 83

Brak uwag

HP VMA-series Memory Arrays Podręcznik Użytkownika Strona 26