HP VMA-series Memory Arrays Podręcznik Użytkownika Pobierz pdf (Strona 35)

AM456-9025A HP VMA SAN Gateway Installation and Configuration Guide 35

• When using LACP, ensure that all network switches are LACP-enabled.

Depending on the switch’s capabilities and configuration, the port LACP settings may be either

active or passive. Active mode is recommended, because only aggregated traffic is expected

from the HP VMA SAN Gateway. For more information, see the HP VMA SAN Gateway User’s

Guide.

Interface Bonding Example

There are many types of bonding modes available, some of which require changing network switch

settings. See the HP VMA SAN Gateway User’s Guide for more information on these modes.

The following example demonstrates how to configure a round-robin balance mode for a bonded

interface that does not require any switch changes. This creates a round-robin bond (eth0), that

effectively combines the eth1 and eth2 interfaces with eth0 virtual IP address (VIP).

To configure a round-robin balance mode interface bond, do the following:

1. Launch a terminal window, enter the host name or IP address of the master SAN Gateway

node in the appropriate text field, and open.

The following screenshot is an example of a PuTTY launch dialog.

A terminal window appears.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 82 83

Brak uwag

HP VMA-series Memory Arrays Podręcznik Użytkownika Strona 35