Hp StorageWorks 1510i Modular Smart Array Instrukcja Użytkownika Pobierz pdf (Strona 52)

2. Select Target > Enable/Disable Access Control.

3. Expand the

ACL State drop-down box, and enable access control.

4. The following warning message is displayed:

5. Conﬁrm that there is no active I/O on the target, and then click OK.

IMPORTANT:

• To prevent loss of access to the storage, ACLs should not be modiﬁed if there is an active

session between the initiator and the target. Before enabling ACL for a target, open

your iSCSI initiator software and verify that the target status is inactive or disconnected.

• When access control is

disabled

(default), all initiators with access to the array controller

can access the storage targets. (If CHAP authentication is set up, only initiators with

veriﬁed CHAP secrets can access the storage.)

• When access control is

enabled

, access to all mapped logical drives of the target is

immediately blocked (Step 2 through Step 3), until ACLs are created for each mapped

logical drive (Step 6 through Step 7).

Conﬁgure

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 98 99

Brak uwag

Hp StorageWorks 1510i Modular Smart Array Instrukcja Użytkownika Strona 52