Hp Netserver E Server series Instrukcja Użytkownika Pobierz pdf (Strona 10)

Chapter 1 Controls, Ports and Indicators

NOTE For more information on the HP Tape Drive and its error

codes, refer to the documentation provided with the tape drive

or refer to Hewlett-Packard’s web site, at:

http://www.hp.com

Refer to Chapter 3, "Installing Mass Storage Devices," for

installation information.

Rear View

The ports and connectors at the rear are listed below and shown in Figure 1-3.

• The power connector accepts a standard power cable to connect the

HP NetServer E 800 with the site power supply.

• The mouse port accepts a standard mouse with a PS/2 connector.

• The keyboard port accepts a standard keyboard with a PS/2 connector.

• Two USB ports are provided for printers, scanners, and external modems.

• The LAN port is included as an embedded controller based on Intel’s

82559 10/100 BaseT Fast Ethernet controller. It has a RJ-45 LAN

connector and two LEDs to indicate LAN speed and valid connection.

Refer to Table 1-3 for the LAN LED indicators.

• The Serial Port A is a standard serial port.

• The Parallel Port is a standard parallel port which supports Extended

Capabilities Port (ECP)/Enhanced Parallel Port (EPP).

• The Serial Port B is a standard serial port.

• The Monitor Port interface specifications are listed in Table A-4, "HP

NetServer Hardware Specifications" and Table A-5, "Video Display

Modes" of Appendix A, "Specifications."

• The optional external SCSI port provides access to external SCSI devices.

The optional HP NetServer E 800 Internal/External SCSI Cable Kit

(PN: P1774A) is required to install an external SCSI port.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 105 106

Brak uwag

Hp Netserver E Server series Instrukcja Użytkownika Strona 10