Hp ProLiant DL385p Gen8 Server Instrukcja Użytkownika Strona 21
- Strona / 135
- Spis treści
- ROZWIĄZYWANIE PROBLEMÓW
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
Component identification 21
1 - Amber 2 - Green 3 - Green Interpretation
Off
Off Off The cache module is not powered.
Off
Flashing 0.5 Hz Flashing 0.5 Hz The cache microcontroller is executing from within its
boot loader and receiving new flash code from the host
controller.
Off
Flashing 1 Hz Flashing 1 Hz The cache module is powering up, and the capacitor
pack is charging.
Off
Off Flashing 1 Hz The cache module is idle, and the capacitor pack is
charging.
Off
Off On The cache module is idle, and the capacitor pack is
charged.
Off
On
On
The cache module is idle, the capacitor pack is charged,
and the cache contains data that has not yet been
written to the drives.
Off
Flashing 1 Hz Off A backup is in progress.
Off
On Off The current backup is complete with no errors.
Flashing 1 Hz
Flashing 1 Hz Off The current backup failed, and data has been lost.
Flashing 1 Hz
Flashing 1 Hz On A power error occurred during the previous or current
boot. Data may be corrupt.
Flashing 1 Hz
On Off An overtemperature condition exists.
Flashing 2 Hz
Flashing 2 Hz Off The capacitor pack is not attached.
Flashing 2 Hz
Flashing 2 Hz On The capacitor has been charging for 10 minutes, but
has not reached sufficient charge to perform a full
backup.
On
On Off The current backup is complete, but power fluctuations
occurred during the backup.
On
On On The cache module microcontroller has failed.
Hot-plug fans
CAUTION: To avoid damage to server components, fan blanks must be installed in fan bays 1
and 2 in a single-processor configuration.
The only two valid fan configurations are listed in the following table.
Configuration Fan bay 1 Fan bay 2 Fan bay 3 Fan bay 4 Fan bay 5 Fan bay 6
1 processor
Fan blank Fan blank Fan Fan Fan Fan
2 processors
Fan Fan Fan Fan Fan Fan
- User Guide 1
- Contents 3
- Contents 4 4
- Contents 5 5
- Contents 6 6
- Component identification 7
- • 8 drive LFF configuration 8
- Front panel LEDs and buttons 9
- Item Description Status 10
- Press and release the panel 10
- Systems Insight Display LEDs 11
- Rear panel components 13
- Rear panel LEDs and buttons 14
- System board components 15
- System maintenance switch 16
- NMI functionality 17
- DIMM slot locations 17
- SAS and SATA device numbers 18
- Drive LED definitions 19
- PCIe riser cage LED 19
- Hot-plug fans 21
- Component identification 22 22
- Operations 23
- Remove the access panel 25
- Install the access panel 25
- Remove the fan cage 26
- Remove the hot-plug fan 27
- Remove the air baffle 34
- Rack planning resources 36
- Optimum environment 36
- Temperature requirements 37
- Power requirements 38
- Rack warnings 39
- Installing hardware options 40
- Registering the server 43
- Introduction 44
- Processor option 44
- Install the air baffle 51
- Memory options 52
- HP SmartMemory 54
- Population order 55
- DIMM identification 56
- Memory configurations 57
- Installing a DIMM 58
- Hot-plug hard drive options 59
- Controller options 61
- 8 or 16 drive SFF 65
- 8 drive LFF 65
- Optical drive option 66
- FlexibleLOM option 69
- Expansion board options 71
- Remove the PCI riser blank 75
- Hard drive cage option 76
- Disconnect the cable 78
- Install the fan cage 83
- 2U rack bezel option 86
- Cabling 90
- Optical drive cabling 91
- FBWC cabling 92
- Chipset SATA cable option 93
- 150W PCIe power cable option 97
- Server mode 98
- HP product QuickSpecs 98
- HP iLO Management Engine 98
- Active Health System 99
- Intelligent Provisioning 100
- HP Insight Diagnostics 101
- Erase Utility 101
- HP Service Pack for ProLiant 102
- HP ROM-Based Setup Utility 103
- Auto-configuration process 104
- Using RBSU 104
- Boot options 105
- Configuring AMP modes 105
- Utilities and features 106
- ROMPaq utility 107
- Automatic Server Recovery 107
- USB support 107
- Keeping the system current 108
- Software and firmware 109
- Version control 109
- ProLiant servers 109
- Troubleshooting 111
- Battery replacement 112
- Battery replacement 113 113
- Regulatory information 114
- Electrostatic discharge 115
- Specifications 116
- Support and other resources 121
- Customer Self Repair 123
- Reparo feito pelo cliente 125
- Acronyms and abbreviations 129
- Trusted Platform Module 131
- Version Control Agent 131
- Documentation feedback 132
- Index 133 133
- Index 134 134
- Index 135 135
Powiązane produkty i podręczniki dla Sprzęt komputerowy Hp ProLiant DL385p Gen8 Server
(93 strony)© 2020, manymanuals.pl. Wszelkie prawa zastrzeżone. | 0.049 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji