HP 132A Instrukcja Użytkownika Pobierz pdf (Strona 255)

Chapter 4 Command Reference

Introduction

Programming Guide 4-89

• *RST: ON

• This value is unaffected by save/recall.

• While the Counter is configured to ON, representative CW signal(s) must be

present at the measurements input(s).

• The ON setting causes the Counter to disregard any previously set “expected

frequency” ([:SENS]:FREQ:EXP[1|2|3]).

• The only mechanism for disabling the above described

pre-measurement step is to specify an expected frequency with

[:SENS]:FREQ:EXP[1|2|3].

[:SENSe]:FUNCtion[:ON] <sensor_function>

Sets or queries the <sensor_function> to be sensed by the Counter.

The <sensor_function> strings are :

“[:][XNONe:]DCYCle [1]”

“[:][XNONe:]PDUTycycle [1]”

“[:][XNONe:]FALL:TIME [1] ”

“[:][XNONe:]FTIMe [1]”

“[:][XNONe:]FREQuency [1|2|3]”

“[:][XNONe:]FREQuency:RATio [ 1,2 | 1,3 | 2,1 | 3,1 ]”

“[:][XNONe:]NWIDth [1]”

“[:][XNONe:]PERiod [1|2|3]”

“[:][XNONe:]PHASe [1,2]”

“[:][XNONe:]PWIDth [1]”

“[:][XNONe:]TINTerval [1,2]”

“[:][XNONe:]TOTalize [1]”

“[:][XNONe:]RISE:TIME [1]”

“[:][XNONe:]RTIMe [1]”

“[:][XNONe:]VOLTage:MAXimum [1|2] ”

“[:][XNONe:]VOLTage:MINimum [1|2] ”

“[:][XNONe:]VOLTage:PTPeak [1|2]”

Comments

1 2 ... 250 251 252 253 254 255 256 257 258 259 260 ... 329 330

Brak uwag

HP 132A Instrukcja Użytkownika Strona 255