HP 132A Instrukcja Użytkownika Pobierz pdf (Strona 72)

Chapter 3 Programming Your Universal Counter for Remote Operation

Configuring the HP-IB

3-4 Programming Guide

Configuring the HP-IB

This section gives information on connecting and configuring the

HP-IB to enable remote operation of the Counter .

The Counter has two HP-IB operating modes :

• Addressed (talk/listen)—This mode is for bi-directional communication. The

Counter can receive commands and setups from the computer, and can send

data and measurement results.

To select the talk/listen operating mode, set the Counter ’s HP-IB address

from 0 to 30. Refer to the following section titled “To Set the HP-IB Mode

and Address” for instructions on how to set an HP-IB address from the front-

panel.

• Talk-only—In this mode, the Counter can send data to a printer. It cannot

receive commands or setups from the computer.

To select the talk-only operating mode, set the Counter ’ s HP-IB mode to

“TALK”. Refer to the following section titled

“To Set the HP-IB Mode and Address” for instructions on how to set the talk-

only mode from the front-panel.

When the Counter is shipped from the factory, it is configured as addressed

(talk/listen) with the address set to “3.”

To Set the HP-IB Mode and Address

1 Press and hold Recall (Utility) key, then cycle POWER.

2 Press Recall (Utility) key until HP-IB: is displayed.

To best demonstrate how to set the address, let’s assume that

HP-IB: 3 is currently being displayed.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 329 330

Brak uwag

HP 132A Instrukcja Użytkownika Strona 72