
prerequisite, you can be alerted by e-mail when each operation completes.
Note: In the current release, after you complete the Admin Node installation, you may continue to use the
Operational Dashboard to modify the following prerequisite values:
Cloud Admin Node Time settings
Email Notification settings
However, after you complete the Admin Node installation, you cannot subsequently change:
Admin Node Internet Access settings
External DNS Server settings
Enable Admin Node Internet Access
To enable the Admin Node Internet Access:
1.
On the Operational Dashboard, select the Environment tab > Prerequisites.
2.
For the Cloud Administration Node Internet Access, click Edit Prerequisite.
3.
Set the Network Interface to the network interface on the Admin Node that has been configured for
Internet access, for example, eth1.
4.
Leave the default Network Configuration checked as DHCP. If you have a static IP address allocated for
the node, uncheck DHCP and fill in the appropriate information.
5.
Set the HTTP Proxy Information applicable for your environment. If you are on a network that has a
proxy, you must fill in this Proxy information.
Caution: Specifying incorrect proxy host settings might cause some features to not work correctly later,
after the installation, when you use the HP Cloud OS for Moonshot Administration Dashboard.
a. Specify the Host's IP address - get this value from your system administrator or from the settings in
your web browser.
b. Specify the Port - get this value from your system administrator or from the settings in your web
browser.
c. Specify the Non-Proxy Hosts' IP addresses - that is, specify addresses that should not use proxy
servers, for the Controller/Baremetal Host and admin networks. Each network needs to be separated by a
pipe bar "|". For example: 10.*|192.*|127.0.*|localhost.
© Copyright 2014 Hewlett-Packard Development Company Page 17
Komentarze do niniejszej Instrukcji