HP Cloud OS for Moonshot Instrukcja Instalacji Pobierz pdf (Strona 21)

Note: You do not have to customize the Admin Network.

Introduction

Based on the network infrastructure suggested in the "Plan the Infrastructure for a Cloud" section of Important

Tasks Before You Install, you must customize the network settings. Here are some of the criteria to be

considered while making changes to the default settings:

For a production deployment, and to reduce the complexities of configuring the switches, it is strongly

recommended that you provide separate wired networks for public and admin. This requires you to

specify your own range of IP addresses and other settings.

Get the details of your public network range from your Network Administrator. You must use a dedicated

assigned IP address range when configuring the cloud's public network.

Some networks and address ranges for those networks are provided by default. You can modify or delete

the IP address ranges as well as add new ones. You must use valid ranges that fall within the subnet as

defined by the subnet address and mask specified in the network details.

Note: Validation of the address ranges only occurs when you open the Edit Address Ranges dialog for each

network and click Update Address Ranges. Otherwise,you will not know if you have any errors. However, the

Complete Install step will run a validation check and cannot be completed until the errors (if any) are fixed. If

there is an address range error, the validation check will show the network type and possibly the address value.

If not, open the Edit Address Ranges dialog for the specified network and click Update Address Ranges to

identify the incorrect address.

Customize the Public Network

To provide external access, make sure you specify a contiguous IP address range in the <External/Public IP

Address Range>. On successful deployment of a Cloud, only the Controller Node gets the external IP address.

Therefore, a small range of this IP pool is sufficient. Get the range from your IT administrator.

Edit the Public Network

To edit the public network:

On the Operational Dashboard, select the Environment tab > Networks.

Click Edit Network for the public Network Type.

Click each tab: Network, VLAN, and Router, one by one, to perform the following actions:

On the Network tab, specify the Subnet and Netmask of your dedicated public IP address range.

Do not change:

page-footer-left

page-footer-right

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 43 44

Brak uwag

HP Cloud OS for Moonshot Instrukcja Instalacji Strona 21