HP Cloud OS for Moonshot Instrukcja Instalacji Pobierz pdf (Strona 24)

Note: If you enter invalid address ranges, you will get a validation error, which identifies the incorrect address

(start or end) for the corresponding network type. You must fix all errors in the Edit Address Ranges dialog and

click Update Address Ranges to validate the addresses are correct.

Customize the IPMI Network

The IPMI network is used for communication between the Baremetal host and the Moonshot Chassis Manager.

This includes chassis and cartridge discovery, power control of cartridges and nodes, and monitoring of the

health of the Moonshot systems.

Edit the IPMI Network

To edit the IPMI network:

On the Operational Dashboard, select the Environment tab > Networks.

Click Edit Network for the public Network Type.

Click each tab: Network, VLAN, and Router, one by one, to perform the following actions:

On the Network tab, specify the Subnet and Netmask of your dedicated public IP address range.

Do not change:

Bridge Enabled = False

On the VLAN tab, do not change:

VLAN Enabled = False

VLANID = 172

On the Router tab, you do not need to specify the Gateway IP address in the Router box, and the

Router Preference default value is sufficient.

Click Update Network to save your changes.

Edit the IPMI Address Ranges

To edit the IPMI address ranges:

In the IPMI Edit Network drop-down list, select Edit Address Ranges to open the Address Ranges

dialog.

The following fields are pre-populated:

Network Type

Subnet values

Node Type - It is set for three types: Host, Router, DHCP.

IPV4 Start Addr displays the start of the IP address range for all three node types.

IPV4 End Addr displays the end of the IP address range for all three node types.

Make the required changes as per your environment.

page-footer-left

page-footer-right

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 43 44

Brak uwag

HP Cloud OS for Moonshot Instrukcja Instalacji Strona 24