HP X Unified Security Platform Series Instrukcja Użytkownika Pobierz pdf (Strona 70)

Chapter 3 IPS Filtering

54 X Family LSM User’s Guide V 2.5.1

Configure the Remote System Log Contact

STEP 1

From the LSM menu, select IPS > Action Sets. Then, on the Action Sets page, click the

Notification Contacts tab.

STEP 2

On the Notification Contacts page in the Contacts List, click the Remote System Log link.

STEP 3

On the Edit Notification Contact page, type the IP Address and Port for the host that receives

the offloaded log messages.

STEP 4

Type the IP Address and Port for the host that will receive Remote System Log messages.

STEP 5

Select an Alert Facility and a Block Facility: none or select from a range of 0 to 31.

These syslog number uses these numbers to identify the message source.

STEP 6

Select a Delimiter for the generated logs: tab, comma, semicolon, or bar.

STEP 7

Click Add to table below to add the remote syslog server.

STEP 8

Enter a Remote system log aggregation period in minutes.

STEP 9

Click Save.

Configure the Management Console Contact

STEP 1

From the LSM menu, select IPS > Notification Contacts. Then, click the Notification

Contacts tab.

STEP 2

Click the pencil icon next to the Management Console entry.

STEP 3

Edit the Contact Name. By default, it is Management Console.

STEP 4

Enter the Aggregation Period for notification messages in minutes.

STEP 5

Click Save.

Delete a Notification Contact

STEP 1

From the LSM menu, select IPS > Action Sets. Then, click the Notification Contacts tab.

STEP 2

On the Notification Contacts page, click the Delete icon to remove the notification contact.

CAUTION Remote syslog, in adherence to RFC 3164, sends clear text log messages using

the UDP protocol with no additional security protections. Therefore, you should only use

remote syslog on a secure, trusted network to prevent syslog messages from being

intercepted, altered, or spoofed by a third party.

TIP

Verify that the device can reach the remote system log server on your

network. If the remote system log server is on a different subnet than the device

management port you may have to add static routes (see “

Static Routes” on

page 159).

Note You cannot delete the default Remote System Log and Management

Console contacts

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 332 333

Komentarze do niniejszej Instrukcji

Brak uwag

HP X Unified Security Platform Series Instrukcja Użytkownika Strona 70

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking HP X Unified Security Platform Series