HP Server rp7400 Instrukcja Użytkownika Pobierz pdf (Strona 17)

Step 1. Remove Power From the System

CAUTION Before starting any shut down type procedures, be sure to

check with the System Administrator or customer to

ensure a system backup has been performed recently.

To shut down and power off the rp7400 computer system,

perform the following steps.

a. Stop all active applications.

b. Perform a normal Operating System shut down, informing

all logged on users of the impending shut down.

c. Once the Operating system has halted, put the power

switch in the standby (0) position.

CAUTION With the power switch in the standby position, there is

still power to the inside of the SPU.

d. Remove A.C. from the SPU by unplugging the power cords

(up to 3) from the back of the SPU.

Step 2. Remove the Front Bezel

a. Grasp the front bezel on each side.

b. Pull the front bezel away from the cabinet.

Step 3. Extend the SPU out the Back of the Cabinet

CAUTION Be aware of the cables at the back of the SPU while

moving the SPU in or out of the cabinet.

To extend the SPU out the back of the cabinet:

a. Remove the four (two on each side) retainer screws, holding

the bezel flange to the cabinet vertical post.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 30 31

Brak uwag

HP Server rp7400 Instrukcja Użytkownika Strona 17