HP Server rp7400 Instrukcja Użytkownika Pobierz pdf (Strona 22)

EMI problems.

To replace the back air baffle in the SPU:

a. Angle the back edge of the air baffle onto the support

bridge flange, then lower the air baffle over the CPU

cooling towers (up to four).

CAUTION Be sure all CPU cooling tower tops are centered in the

support brackets. The support brackets have enough

play in them to allow proper alignment.

b. Be sure the air baffle sits flush into the SPU.

c. Tighten the two captive screws at the support bridge.

Step 10. Replace the Back Top Cover

To replace the back top cover in the SPU:

a. Angle the back edge of the top cover into the support

bridge. Be sure the tabs at the back edge of the top cover

insert into the slots on the support bridge.

b. Lower the top cover onto the SPU. Firmly press the top

cover down onto the SPU, making sure the outer edges of

the top cover are over the top edges of the chassis.

c. Tighten the two captive screws.

Step 11. Insert the SPU Back into the Cabinet

CAUTION Be aware of the cables at the back of the SPU while

moving the SPU in or out of the cabinet.

To insert the SPU into the cabinet from the back:

a. Press the rail slide locks (one on each side) to release the

rail locks while gently pushing the SPU forward.

b. Carefully insert the SPU all the way into the cabinet until

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 30 31

Brak uwag

HP Server rp7400 Instrukcja Użytkownika Strona 22