HP Server rp7400 Instrukcja Użytkownika Pobierz pdf (Strona 21)

DIMM) press the memory DIMM into the memory carrier

slot until the memory DIMM fully seats and the extractor

levers are up against the outside edges of the memory

DIMM.

c. Pick up the memory carrier and visually check to see that

all memory DIMMs are seated fully. No memory DIMM

card edge should be higher than the others. This indicates

that a memory DIMM is not fully seated into the memory

carrier slot. Press firmly on the raised edge to seat the

memory DIMM into its’ socket.

d. Replace the memory DIMM hold down bracket.

Step 8. Replace the Memory Carrier

The memory carriers (up to four) are located along the back of

the SPU. Memory carriers are installed from slot 0 through

slot 3 (slot 0 is the right most slot facing the back of the SPU).

To replace the memory carrier in the SPU:

a. While holding the memory carrier by the extended

insertion/extractor levers, align the memory carrier with

the appropriate slot card guides on the system board.

b. Carefully lower the memory carrier into the card guides,

until the insertion/extractor levers hook under the card

guide edges.

c. Press the insertion/extractor levers down until the memory

carrier firmly seats into the system board. The

insertion/extractor levers should be parallel with the

memory carrier edge.

Step 9. Replace the Back Air Baffle

CAUTION Operating the SPU without the back air baffle will create

air flow problems and possibly shorten the life of the

internal components. Hewlett-Packard does not

recommend the SPU be powered on with the air baffles

removed. Also, operation of the SPU without the top cover

and air baffle in place can make the SPU susceptible to

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 30 31

Brak uwag

HP Server rp7400 Instrukcja Użytkownika Strona 21