Hp D2D100 Backup System Instrukcja Użytkownika Pobierz pdf (Strona 102)

Restoring from

the HP D2D Backup System

This is very eas

y and fast. Run your backup software and select the ﬁles to be restored. Although the

software appl

ication is tape-based, the restore performance on your HP D2D Backup System is much

faster than restoring from physical tape.

Reconnecting to the HP D2D after host failure

Each conﬁgured autoloader or tape drive on the HP D2 D Backup System is uniquely mapped to a host. It

cannot be seen by any other host on the network. If the host system fails, you must replace it and

reconﬁgure the mapping of the host to the conﬁguredbackupdeviceontheHPD2DBackupSystem.

1. Install the operating system on the host. If possible, give the host the same Computer Name as the

host that failed.

2. Install the backup application on the host.

Run the iSCSI Initiator on the restored host. (See also “The iSCSI Initiator”onpage47.)

4. Make a note of the Initiator Nod e Name from the G eneral tab.

5. Modifythetargetautoloadertoseethenewmachinenameoftherestoredhost.SelecttheDevices

page on the Web Management Interface, and put the target autoloader into Edit mode. Copy the

host’s Initiator Node Name (found on the G eneral tab in step 4 ) into iSCSI Initiator Name.

102

Restore processes

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 125 126

Brak uwag

Hp D2D100 Backup System Instrukcja Użytkownika Strona 102