HP ProDesk 600 G4 Base Model Small Form Factor PC Instrukcja Użytkownika Pobierz pdf (Strona 54)

Connector board

Follow these steps to remove the connector board:

1. Prepare the computer for disassembly (see Preparation for disassembly on page 28).

2. Remove the access panel (see Access panel on page 29), and then remove the following components:

a. Front bezel (see Front bezel on page 31)

b. Drive cage (see Drive cage on page 34)

c. Shroud (see Fan shroud on page 38)

d. System board (see System board on page 43)

Remove the connector board:

1. Remove the two Phillips PM2.0×3.5 screws (1) that secure the connector board to the system board.

2. Remove the connector board (2).

NOTE: When the connector board is removed, make sure the connector board bracket does not become

separated from the board.

Reverse this procedure to install the connector board.

46 Chapter 4 Removal and replacement procedures

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 123 124

Brak uwag

HP ProDesk 600 G4 Base Model Small Form Factor PC Instrukcja Użytkownika Strona 54