Hp NonStop G-Series Instrukcja Użytkownika Pobierz pdf (Strona 78)

5157/5157 ACL S-Series DLT Subsystems installation Users Guide

Installing and Configuring the 5157 ACL Tape Subsystem

5-5

÷÷ Set Data Format

Set SCSI

Set Library Mode

Set Element Base ê

Figure 5-5 Configure Submenu

4. To select a configuration option, press the ù or ü button on

the control panel until the ÷ on the display is next to the option

to change. In this case choose Set SCSI. Press the Enter button

to display the choices for that option. The submenu in Figure 5-

6 appears.

÷÷ Library Parity:

*Enabled

Library Bus ID:

*3 ê

Figure 5-6 Set SCSI Submenu

Note: Take a moment to look closely at the submenu in Figure 5-6.

Note that the ÷ on the display is next to line 1, and that line 2 is

indented. This says that Figure 5-5 is a two-tiered menu. The ù and

ü buttons work on two levels in this kind of menu, which is typical

of many submenus of the Configure Menu. The first level is as

follows: If the ü button is pressed, the ÷ moves to line 3. Pressing

the ü button again will scroll down to ‘DLT Bus ID.’ If the ù

button is pressed, the ÷ moves back to line 1.

If the Enter button is pressed while the ÷ is next to line 1 (or line

3), the ù and ü buttons operate on the second level. It is obvious

because the ÷ moves next to line 2 (or line 4), and a êê appears at

the end of line 4, indicating that there is a list of settings that can be

scrolled using the ù and ü buttons.

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 180 181

Brak uwag

Hp NonStop G-Series Instrukcja Użytkownika Strona 78