HP 5300 Informacje Techniczne Pobierz pdf (Strona 187)

Port Status and Basic Configuration

Viewing Port Status and Configuring Port Parameters

The Auto-MDIX features apply only to copper port switches using twisted-pair

copper Ethernet cables.

Syntax: interface ethernet < port-list > mdix-mode < auto-mdix | mdi | mdix >

auto-mdix is the default. This configures the port for automatic

detection of the cable (either straight-through or crossover)

mdi configures the port for connecting to a PC or other MDI device

with a crossover cable (Manual mode)

mdix configures the port for connecting to a switch, hub, or other

MDI-X device with a straight-through cable (Manual mode)

Use show interfaces brief to list the settings the switch has

negotiated in the case of the auto-mdix setting, or to list the state

the switch has set in the case of mdi, mdix, and auto-mdix before

link. To see these settings using the menu interface choose the

“4. Port Status” option under “1. Status and Counters”.

Use show interfaces config to list the running configuration for auto-

mdix.

Note Upgrading the switch Operating System from E_07.XX or before:

1. Copper ports in auto-negotiation still default to auto-mdix mode.

2. Copper ports in forced speed/duplex default to mdix mode.

For a fresh installation of the operating system auto-mdix is the default.

Web: Viewing Port Status and Configuring Port

Parameters

In the web browser interface:

1. Click on the Configuration tab.

2. Click on

[Port Configuration].

3. Select the ports you want to modify and click on

[Modify Selected Ports].

4. After you make the desired changes, click on

[Apply Settings].

Note that the web browser interface displays an existing port trunk group.

However, to configure a port trunk group, you must use the CLI or the menu

interface. For more on this topic, refer to chapter

12, “Port Trunking” .

10-13

1 2 ... 182 183 184 185 186 187 188 189 190 191 192 ... 441 442

Brak uwag

HP 5300 Informacje Techniczne Strona 187