HP 5300 Informacje Techniczne Strona 327

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 326
File Transfers
Transferring Switch Configurations and ACL Command Files
For more on this general topic, including an example of an ACL command file
created offline, refer to the section titled “Editing ACLs and Creating an ACL
Offline” in the “Access Control Lists (ACLs)” chapter of the Advanced Traffic
Management Guide for your switch.
Xmodem: Copying a Configuration File from the Switch to a
Serially Connected PC or UNIX Workstation
To use this method, the switch must be connected via the serial port to a PC
or UNIX workstation to which you want to copy the configuration file. You
will need to:
Determine a filename to use.
Know the directory path you will use to store the configuration file.
Syntax:
copy < startup-config | running-config > xmodem < pc | unix >
Uses Xmodem to copy a configuration file from the switch to
a PC or Unix workstation.
For example, to copy a configuration file to a PC serially connected to the
switch:
1. Determine the file name and directory location on the PC.
2. Execute the following command:
3. After you see the above prompt, press
[Enter].
4. Execute the terminal emulator commands to begin the file transfer.
Xmodem: Copying a Configuration File from a Serially
Connected PC or UNIX Workstation
To use this method, the switch must be connected via the serial port to a PC
or UNIX workstation on which is stored the configuration file you want to
copy. To complete the copying, you will need to know the name of the file to
copy and the drive and directory location of the file.
Syntax:
copy xmodem startup-config < pc | unix >
Copies a configuration file from a serially connected PC or
UNIX workstation to the switch’s startup-config file.
A-23
Przeglądanie stron 326
1 2 ... 322 323 324 325 326 327 328 329 330 331 332 ... 441 442

Komentarze do niniejszej Instrukcji

Brak uwag