HP 5300 Informacje Techniczne Pobierz pdf (Strona 253)

100

101

Port Traffic Controls

Rate-Limiting

Configuring Inbound Rate-Limiting

This command controls inbound usage of a port by setting a limit on the

bandwidth available for inbound traffic.

Syntax: [no] int < port- list > rate-limit < 0..100 >

Configures an inbound traffic rate limit (on non-trunked

ports) as a percentage of the bandwidth available on the link.

You can configure a rate limit from either the global

configuration level (as shown above) or from the port context

level. The "no" form of the command disables rate-limiting on

the specified ports. (Default: Disabled.)

Notes:

– Rate-Limiting applies only to non-trunked ports.

– Configuring a rate limit of 0 (zero) on a port blocks all

inbound traffic on that port. However, if this is the de-

sired behaviour for the port, HP recommends that you

use < port-list > disable to disable the port instead of

configuring a rate limit of 0.

For example, either of the following commands configures an inbound rate

limit of 60% on ports A3 - A5:

HPswitch (config)# int a3-a5 rate-limit 60

HPswitch (eth-A3-A5)# rate-limit 60

13-11

1 2 ... 248 249 250 251 252 253 254 255 256 257 258 ... 441 442

Komentarze do niniejszej Instrukcji

Brak uwag

HP 5300 Informacje Techniczne Strona 253

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie HP 5300