HP Embedded Firewall Series Instrukcja Użytkownika Pobierz pdf (Strona 9)

Installing and Connecting the NIC

2 Unpack and inspect the NIC for damage.

3 Exit all open applications and user processes.

4 Turn off the power to the computer and attached devices.

5 Unplug the power cables from the power source.

6 Remove the computer cover.

7 Locate an empty, non-shared bus-mastering PCI slot and remove its slot cover.

Save the screw, if there is one.

Do not install the NIC in a shared PCI slot. Avoid any PCI slot next to an ISA slot.

This slot is often shared and does not support bus mastering.

If you do not know how to identify a PCI slot, check the computer documentation or

ask the system administrator.

8 Write down the MAC address of the NIC and note the relative position of the

intended PCI slot.

The MAC address is the 12-digit hexadecimal number printed on the small bar code

label on the component side of the NIC. This information is helpful when you are

installing the network drivers and connecting the cables to the hub or switch.

The next step is to install the NIC in the computer and connect it to the network, as

described in the next section.

Installing and Connecting the NIC

Observe the safety precautions listed in “Safety Precautions” on page 2.

The following instructions apply to installing the NIC in most computers. If these

instructions are not appropriate for your computer, refer to the documentation that

accompanied the computer.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 85 86

Brak uwag

HP Embedded Firewall Series Instrukcja Użytkownika Strona 9