HP Integrity NonStop H-Series Podręcznik Użytkownika Pobierz pdf (Strona 146)

HP NonStop Shadowbase Command Definitions

Consumer Command Descriptions

HP NonStop Shadowbase Command Reference Manual—785421-002

137

When TURBOMODE is OFF and IPMBLOCKING is ON, the

Collector will block when it has time (waiting on CONS messages to

complete).

LATENCYCLOCKADJ hundredths

Initial Changed

Version Version Values Default Minimum Maximum Alter

2.603 0 -2147483647 2147483647 Yes

Client Server Extended Open Target

Defines a + or - differential to be used for calculating latency when the

source and target system clocks are not synchronized. The value is

subtracted from or added to the system clock before

LATENCYTHRESHOLD is evaluated. The valid values are -2147483647

through 2147483647. Input a minus sign (-) for a negative adjustment;

enter no sign for a positive adjustment. The default is 0.

LATENCYTHRESHOLD hundredths

Initial Changed

Version Version Values Default Minimum Maximum Alter

2.603 0 Off 0 2147483647 Yes

Client Server Extended Open Target

This sets the tolerance for latency monitoring. The value is added

following the processing of an audittrail event (i.e.,i.e., replicated to target),

the Consumer will add this to the associated event timestamp and

compare the result to current time to see if the threshold has been

exceeded. The default is 0 and means that Consumer latency monitoring

is off. Valid values are 0 to 2147483647.

LATENCYWARNRATE seconds

Initial Changed

Version Version Values Default Minimum Maximum Alter

2.603 0 0 2147483647 Yes

Client Server Extended Open Target

Sets the rate at which EMS messages are generated when the Consumer

has exceeded or recovers from exceeding the LATENCYTHRESHOLD.

Valid values are 0 to 2147483647. Note that you should choose a

reasonable value for this parameter for your operating environment. If the

value is set too low, it is quite possible that the EMS log will become

flooded with messages and impede HP Shadowbase performance. While

the default is 0; a value of 60 is recommended, when the parameter

LATENCYTHRESHOLD is set to a value greater than 0, to avoid flooding

EMS when a "behind" condition exists.

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 345 346

Komentarze do niniejszej Instrukcji

Brak uwag

HP Integrity NonStop H-Series Podręcznik Użytkownika Strona 146

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie HP Integrity NonStop H-Series