
Table B-2 RGS Receiver error messages (continued)
Setup Mode hotkey sequence too short. The key sequence specified by the user is too short.
Setup Mode hotkey sequence too long. The key sequence specified by the user is too long.
Setup Mode hotkey sequence may only consist of Ctrl, Alt, Shift
and Space.
The key sequence specified by the user contains invalid keys.
A space may only be entered after Ctrl, Alt or Shift is pressed. The Setup Mode hotkey sequence cannot start with a space.
Setup Mode hotkey sequence is invalid. The sequence has been
reset to the default.
The Setup Mode hotkey sequence specified using a property
either on the command-line or in the property configuration file is
invalid, and has been reset to the default.
Setup Mode hotkey sequence is invalid. The sequence has been
disabled.
The Setup Mode hotkey sequence specified using a property
either on the command-line or in the property configuration file is
invalid, and the property Rgreceiver.Hotkeys.IsMutable is
disabled. Therefore, hotkeys have been disabled.
Unable to connect to Sender: The Receiver was unable to resolve
the specified hostname or IP Address. Verify that you entered the
value correctly.
This is usually indicative of a DNS error.
Unable to connect to Sender: The Receiver resolved the specified
hostname or IP address, but cannot connect to the Sender. Verify
that the system is accessible on your network and that the
Remote Graphics Sender service has been started and is listening
on a pubic IP address and is not blocked by a firewall.
The RGS Receiver was able to look up and resolve the specified
hostname or IP address. However, the RGS Receiver was unable
to establish a connection to the RGS Sender. There are several
possibilities such as the RGS Sender is not installed, the RGS
Sender is not running, the RGS Sender is listening on the wrong
network interface, or a firewall is blocking the RGS Sender.
RGS error messages 107
Komentarze do niniejszej Instrukcji