HP 6000 Router Series Instrukcja Instalacji Pobierz pdf (Strona 15)

Introduction to General Modules 15

Figure 5 LEDs and buttons

Interface Console interface

Table 4 RPU LED and button description

LED and button Description

RUN

(Green)

RPU System operation LED. Blinking means the CPU is

in normal operation, constant ON or OFF means

the CPU has failed.

FAN FAN operation LED. Constant ON means the FAN

is operating normally.

PWR1 PWR1 operation LED. Constant On means PWR1

is operating normally, and constant OFF means

that PWR1 is not in place or has failed.

PWR2 PWR2 operation LED. Constant ON means PWR2

is operating normally, and constant OFF means

PWR2 is not in place or has failed.

ALM

(red)

RPU System failure LED. ON means CPU has recieved

an alarm signal for PWR or FAN (due to

overheating, for example).

FAN FAN failure LED. ON means the FAN is not in

place or its rotation is obstructed.

PWR1 PWR1 failure LED. ON means PWR1 has failed.

PWR2 PWR2 failure LED. ON means PWR2 ahs failed.

RESET RPU hardware reset button.

10/100BASE-TX LED LINK (green) OFF means the link is not connected and ON

means the link is connected.

ACT (yellow) OFF means no data is being transcieved on the

interface and blinking means data is being

transcieved.

Table 5 Console interface attributes

Attribute Description

Connector RJ45

Interface standard RS232

Baud rate 9600bps ~ 115200bps

9600bps by default Supported service

Connect to the ASCII terminal Connect to the serial interface of the local PC and run

terminal emulation program on the PC

Command Line Interface (CLI)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 81 82

Brak uwag

HP 6000 Router Series Instrukcja Instalacji Strona 15