HP 6000 Router Series Instrukcja Instalacji Pobierz pdf (Strona 77)

2-port ADSL (over POTS) FIC (3C13872) 77

The following table describes the LEDs on the card panels.

Interface Cable 2-port ADSL FIC interface cables are regular telephone cables.

The standard equipping package of 2-port ADSL FIC includes the regular

telephone cable(s).You can separately order an external splitter as needed.

Interface Cable In G. Lite mode, no splitter is required. You can directly connect one end of the

telephone cable to the Router and the other end to the PSTN, and simply connect

the phone-set and the Router in parallel at the cable distribution box.

In full rate mode, a splitter is required. Follow these steps to connect the cables:

1 Plug one end of a telephone cable into the ADSL port on the Router, and the other

end into the inbound ADSL port on the splitter.

2 Connect the telephone to the phone port on the splitter with another telephone

cable.

3 Connect the outbound ADSL port on the splitter to the PSTN with a third

telephone cable.

Figure 20 Connect 2-port ADSL FIC

Table 20 LED description 2-port ADSL FIC

LINK

OFF means that the line is inactive, ON means that the line has been activated

and has entered the data mode, and blinking means that the line is being

activated.

ACT

OFF means no data is being transceived on the interface and blinking means data

is being transceived.

Router

Splitter

PSTN

Modem port

Phone port

Line

port

ADSL card

RJ11 port