HP 6000 Router Series Instrukcja Instalacji Pobierz pdf (Strona 50)

50 CHAPTER 5: HARDWARE MAINTENANCE

3 Plug one end of the power cord shipped with the chassis into the socket in the

power module, and connect the other end to the power supply.

4 Turn on the power switch.

5 Check if the power status indicator ON the RPU is normal.

Fan Removal and

Installation

The fan is used for exhausting air to cool the cards. The fan is installed vertically to

the right side inside the integrated chassis.

Remove a Fan

1 Loosen the two captive screws of a fan.

2 One hand holds the handle attached to the front of the fan and pulls part of it

out, while the other hand holds the bottom of the fan.

3 Pull the whole fan out after it completely stops rotating.

The fan is rather long, and therefore use one hand to hold the bottom of the fan

while the other hand holds the handle attached to the front of the fan and pull it

out slowly. Be careful and do not put your finger into the rotating fan.

Figure 2 Fan Removal

Install a Fan

1 Hold the handle attached to the front of the fan with one hand and hold the

bottom with the other hand. Slowly insert the fan into the chassis along the

guides until it touches the rear panel.

2 Fasten the captive screws of the fan.

3 Check if the fan status indicator on the RPU is normal.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 81 82

Brak uwag

HP 6000 Router Series Instrukcja Instalacji Strona 50