HP 6000 Router Series Instrukcja Instalacji Pobierz pdf (Strona 51)

RPU Removal and Installation 51

RPU Removal and

Installation

Remove an RPU

1 Power off the router. (If there are two power modules installed, turn both of them

off.)

2 Loosen the captive screws at both sides of the RPU.

3 Pull the handles at both side of the RPU outward and gently pull the RPU out

along the guides until the whole card is separated from the chassis.

Figure 3 RPU Removal

Install an RPU

1 Power off the router. (If there are two power modules installed, turn both of them

off.)

2 Align the corners of the far edge with the guides in RPU slot and push the RPU

inside the router. At the same time, push the handles at both sides of the RPU

inward until it touches the RPU panel.

3 Fasten the captive screws and fix the RPU on the router.

4 Turn ON power.

5 Check if the fan status indicator on the RPU is normal after powering on the

router.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 81 82

Brak uwag

HP 6000 Router Series Instrukcja Instalacji Strona 51