HP 6000 Router Series Instrukcja Instalacji Pobierz pdf (Strona 49)

HARDWARE MAINTENANCE

Hardware

Maintenance

Please review the following cautions before installation or maintenance:

■ On a mounting screw of 3Com 6000 series router chassis, there is an

anti-dismantle seal of 3Com Corporation. The seal must be kept intact

before the support agent performs maintenance on the switch.

■ Remember to wear ESD-preventive wrist strap.

Power Module

Removal and

Installation

6000 Series Routers support 1+1 redundant power system. The power modules

are hot-swappable.

Remove a Power

Module

1 Turn off power switch.

2 Remove the power cord connected to the power module to be removed and

loosen the two captive screws in the top panel of the module.

3 Hold the handle of the module and gently pull the module out along the guides.

Figure 1 Power Module Removal

Install a Power Module

1 Hold the handle of the power module panel, slowly push the module into the

chassis along the guides until it touches the rear power panel inside the power slot

of the chassis.

2 Fasten the two captive screws in the power module panel.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 81 82

Brak uwag

HP 6000 Router Series Instrukcja Instalacji Strona 49