HP 6000 Router Series Instrukcja Instalacji Pobierz pdf (Strona 34)

34 CHAPTER 3: CONFIGURING THE ROUTER

Decompress Application

If the application files read into the SDRAM pass the checking, they will be

decompressed. And the terminal screen displays the following information:

Begin Decompressing

............................................................

Packet Decompress is completed!

Initialize the system

After decompression, the Boot ROM program ends and the depressed application

will be executed. The terminal screen displays the following information:

Booting...

Be Sure The Baudrate Be Set To 9600bps!

GT64260 Version->[B].

usrRoot() end

leave BSP

root begin...

Init 28F128...

Begin to start the system, please waiting......

......

line Con 0 is available.

Press ENTER to get started.

Router Configuration

Fundamentals

Basic Configuration

Procedure

In general, the configuration steps are as follows:

1 Before configuring a Router, you will need specific, detailed networking

requirements. They include networking purpose, the role of the Router in the

network, the division of subnets, the type of the WAN and transmission medium,

and the network security policy and reliability.

2 Based on the above requirements, draw a clear and detailed networking diagram.

3 Configure the WAN interface of the Router. First, configure the physical operating

parameters (such as synchronous/asynchronous serial interface, baud rate and

synchronous clock) of the interface according to the transmission medium of the

WAN. For the dial-up interface, you need to configure DCC parameters. Second,

configure the link layer protocol encapsulated on the interface and the related

operating parameters according to the type of the WAN.

4 Configure the IP addresses or IPX network number of all the interfaces of the

Router according to the division of the subnets.

5 Configure the routes. If it is necessary to enable the dynamic routing protocol,

configure the related operating parameters of the protocol.

6 If there is any special security requirement, perform the security configuration for

the Router.

7 If there is any special reliability requirement, perform the reliability configuration

for the Router.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 81 82

Komentarze do niniejszej Instrukcji

Brak uwag

HP 6000 Router Series Instrukcja Instalacji Strona 34

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking HP 6000 Router Series