HP 6000 Router Series Instrukcja Instalacji Pobierz pdf (Strona 16)

16 CHAPTER 1: INTRODUCING THE ROUTER 6000 FAMILY

AUX interface

Ethernet interface

The RPU provides two 10/100Base-TX Ethernet ports on its panel (Ethernet 0/0/0

at left and Ethernet 0/0/1 at right). Their attributes are listed in the following table.

Power Modules The power modules of 3Com 6000 Routers can work in either single-power or

dual-power mode. In dual-power mode, the two Power Modules function in a

redundant loading sharing mode. The input interruption or failure of a PWR does

not affect the operation of another PWR, and this operating PWR will provide all

the power required by the system.

Power Modules control functions of overcurrent protection and overvoltage

protection.You can connect the PWR to the backplane by inserting it from the rear

of router chassis. It is hot swappable and its switchover will not affect the ongoing

system operation.

If you want to install a 6000 Router in a communication equipment room, you

should make sure that the power distribution cabinet can provide the lightning

protection box or arrester against the current of 20KA and above.

Table 6 AUX interface attributes

Attribute Description

Connector RJ45

Interface standard RS232

Baud rate 300 ~ 115200bps

Supported service Modem dialup

Backup

Table 7 Ethernet interface attributes

Attribute Description

Connector RJ45

Interface type MDI

Supported frame format Ethernet_II

Ethernet_SNAP Operating mode

10M/100Mbps auto-sensing Full duplex/Half-duplex

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 81 82

Brak uwag

HP 6000 Router Series Instrukcja Instalacji Strona 16