Hp StorageWorks DAT 72x10 Tape Autoloader Instrukcja Użytkownika Pobierz pdf (Strona 31)

• You c an order data and cleaning cartridges at www.hp.com/go/storagemedia.

• Clean the tape drive weekly and when the Clean Drive LED is illuminated.

• Be sure to use only HP DDS cleaning c artridges.

• Do not drop a cartridge. Excessive shock can damage the internal contents of the cartridge, or

the

cartridge case itself, making that cartridge unusable.

• Do not expose your data cartridges to direct sunlight or sources of heat, including portable

heaters and heating ducts.

• The operating temperature range for your data cartridges is 5 to 32º C. The storage temperature

range is -40 to +45º C i n a dust-free environment in which relative humidity is always bet ween

percent and 80 percent (non-condensing).

• If the data car tridge has been exposed to temperatures outside the ranges speciﬁed above,

stabilize the cartridge at room temperature for the same amount of time it was exposed to extreme

temperatures or 24 hours, whichever is less.

• Do not place data cartridges near sources of electromagnetic energy or strong magnetic

ﬁelds such as computer monitors, electric motors, speakers, or X-ray equipment. Exposure to

electromagnetic energy or magnetic ﬁelds can destroy data and the emb edded servo code

written on the media by the cartridge manufacturer, which ca n render the cartridge u nusable.

• Place identiﬁcation labels only in the designated area on the cartridge.

Labeling tape cartridges

Never us

non-standard labels, and never stick anything to the cartridge other than in the label areas.

Do not

stick more than one label onto each label area; extra labels can cause the cartridges to jam

in thetapedrive.

Write-protecting tape cartridges

All rewritable data cartridges have a write-protect switch to prevent accidental erasure or overwriting of

data. Before loading a cartridge into the autoloader, make sure the write-protect switch on the rear of

the

cartridge is in the d esired position.

• Slide the switch so that the recognition hole is open to write-protect the car tridge (see Figure 13).

• Slide the switch so that the recognition hole is closed to write data to the cartridge (see Figure 13).

DAT 72x10 1U Tape Autoloader

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 61 62

Brak uwag

Hp StorageWorks DAT 72x10 Tape Autoloader Instrukcja Użytkownika Strona 31