Hp StorageWorks DAT 72x10 Tape Autoloader Instrukcja Użytkownika Pobierz pdf (Strona 39)

Conﬁguration

The Conﬁguration menu provides access to the following autoloader con ﬁguration options:

•

Setting the language, page 39

•

Changing the dr

ive

SCSI ID, page 39

•

Setting autoloader behaviors, page 40

• Setting the autoloader date and time, page 41

To access the Conﬁguration menu:

1. From the H om e

screen, press Previous or Next until the screen displays Configuration.

Press Enter to select.

2. Press Previous or Next until the screen displays your selected function. Press Enter to select.

Setting the language

To change the language in which messages are displayed o n the operator control panel, do the following:

1. From the H om e screen, press Previous or Next until the screen displays Configuration.

Press Enter to select.

2. Press Previous or Next until the screen displays Set Language.Press Enter to select.

3. The screen will display the current language. Press Previous or Next to display the available

languages. Press Enter to select a speciﬁc language.

Changing

the

drive SCSI I D

CAUTION:

If you change the SCSI ID, you may also cycle power on the host server and reconﬁgure your backup

software before you can use the autoloader.

NOTE:

You cannot conﬁgure theLUNs. Thedrive will always be LUN0 andthe autoloader will alwaysbeLUN

1. If the backup software and host are only detecting the drive, then the HBA may not support LUN

scanning or LUN scanning may not be enabled.

To change the drive SCSI address, do the following:

1. From the H om e screen, press Previous or Next until the screen displays Configuration.

Press Enter to select.

2. Press Previous or Next until the screen displays Change Drive SCSI ID.Press Enter to

select .

3. The screen will display the current SCSI ID. Press Previous or Next to change the SCSI ID number.

Press Enter to select. An example of the screen display is Drive SCSI ID=6.

NOTE:

Do not use SCSI ID 7, which is reserved for the SCSI controller. SCSI ID 0 is typically

assigned to the boot disk and should also not be used unless the autoloader is on a

dedicated SCSI bus.

DAT 72x10 1U Tape Autoloader

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 61 62

Komentarze do niniejszej Instrukcji

Brak uwag

Hp StorageWorks DAT 72x10 Tape Autoloader Instrukcja Użytkownika Strona 39

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Przechowywanie Hp StorageWorks DAT 72x10 Tape Autoloader