Hp StorageWorks DAT 72x10 Tape Autoloader Instrukcja Użytkownika Pobierz pdf (Strona 43)

IMPORTANT:

If the cleaning cartridge is not a valid cleaning cartridge, the LCD screen will display Invalid

Cartridge

andthe cartridgewillbeput back into theslotfrom which it originated.

IMPORTANT:

If the Clean drive LED, or the Media Attention LED (on load or unload) occurs when inserting the

same cartridgeafter youhavecleaned the drive,there maybe a problemwiththat cartridge.

Make sure there

is a

cleaning cartridge in one of the magazines before beginning the cleaning steps.

To clean the tape drive:

1. From the Home Scre en, press Previous or Next until the screen displays Operations.Press

Enter to

selec

2. Press Previous or Next until the screen displays Clean Drive.Press Enter to select.

3. The screen will display the drive cleaning status. Press Enter to continue.

4. The screen will display Cleaning Tape slot XX, where XX represents ﬂashing blocks. The

operator mus

select the slot where a cleaning cartridge resides.

5. Use Previou

s or Next

to display the location of a cleaning cartridge.

6. When the cor

rect location for the cleaning cartridge is displayed, press Enter to select. While the

autoloader is cleaning the drive, Drive Cleaning in progress will be displayed.

7. After the cleaning is complete, the screen will either display Drive Cleaning Complete,or

Drive Cleaning

Failed. If the cleaning failed, p ress Enter to display the error code and

message explaining the failure.

The autoloader will return the cleaning car tridge to the original slot. When the tape drive cleaning is

complete, the Clean drive LED turns off (if previously on).

Moving cartridges within the autoloader

The Move Cartridge option lets you move a cartridge from the tape drive or a tape slot in any

magazine to any other location not already holding a cartridge. This option also lets you load and

unload tape cartridges to and from the tape drive. To use this command, you must ﬁrst select where you

want to move the cartridge from and then indicate where you want to move the cartridge to.

To move a cartridge in the autoloader, do the following:

1. From the Home screen, press Previous or Next until the screen displays Operations.Press

Enter to

select.

2. Press Previous or Next until the screen displays Move Cartridge.Press Enter to select.

3. Use Previous or Next to select from the three possible sources:

• LeftMagazine(slots1-5)

• Right Magazine (slots 6-10)

• Drive

4. When the correct source is displayed, press Enter to select.

5. If the source selected is Left Magazine,use Previous or Next to select theslot(thesame

will apply for the Right Magazine). Only slots with cartridges will be listed. The second line

reads Full.

6. Once the correct slot is displayed, press Enter to select .

You have now selected the cartridge you would like to move. The screen will now request the destination

for this cartridge .

DAT 72x10 1U Tape Autoloader

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 61 62

Komentarze do niniejszej Instrukcji

Brak uwag

Hp StorageWorks DAT 72x10 Tape Autoloader Instrukcja Użytkownika Strona 43

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Przechowywanie Hp StorageWorks DAT 72x10 Tape Autoloader