Hp StorageWorks DAT 72x10 Tape Autoloader Instrukcja Użytkownika Pobierz pdf (Strona 44)

1. Use Previous or Next to select from the three possible destinations as follows:

•Right Magazine

•Left Magazine

•Drive

2. When the correct destination is displayed, press Enter to select.

3. If the destination selected is Left Magazine,use Previous or Next to display the slot. O nly

empty slots will be listed.

Once the correct slot is displayed, press Enter to select. The autoloader will now move the cartridge

from the selected source to the selected destination. While the cartridge is being moved, the screen will

display Moving Cartridge. Once the cartridge has been moved, the screen will display either

Move

Complete,or Move Failed.If the move failed, press Enter to display the error c ode and

message explaining the failure.

Updating tape car tridge inventory

The Per form Inventory option lets you update the inventory status of the autoloader. The autoloader will

analyze eac

slot and d rive to determine if cartridges are present or not.

1. From the Home screen, press Previous or Next until the screen displays Operations.Press

Enter to

select.

2. Press Prev

ious or Next

until the screen d isplays Perform Inventory.Press Enter to select.

3. While the inventory is in progress, the screen will display Inventory in Progress.

The autoloader will now check the drive and each slot for the presence of a cartridge in order to update

the

inventory information.

NOTE:

This command is only needed if the inventory in the autoloader is different than the inventory displayed

the fro

panel, which would not happen under normal conditions.

Resetting the autoloader

This o ption resets the autoloader and the tape drive within the a utoloader and forces a new cartridge

inventory, clearing any current error condition.

CAUTION:

This option interrupts any current backup or restore operation and will cause the operation to fail. It is

primarily used if the autoloader is i n an error state.

To reset the autoloader:

1. From the Home screen, press Previous or Next until the screen displays Operations.Press

Enter

select.

2. Press Previous or Next until the screen d isplays Reboot Autoloader.Press Enter to select.

Activating OBD R mode

HP One-Button Disaster Recovery is a standard feature on all HP StorageWorks DAT autoloaders and

tape

drives. However, it c an only be used with speciﬁcconﬁgurations and will only recover the server to

which the tape drive is directly connected.

To check whether your system (hardware, operating system and backup software) is OBDR-compatible,

please refer to our World Wide Web site w

ww.hp.com/go/connect.

Autoloader administr ation

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 61 62

Komentarze do niniejszej Instrukcji

Brak uwag

Hp StorageWorks DAT 72x10 Tape Autoloader Instrukcja Użytkownika Strona 44

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Przechowywanie Hp StorageWorks DAT 72x10 Tape Autoloader