HP D2D2502i Podręcznik Użytkownika Pobierz pdf (Strona 110)

system enable failover

NOTE: This command applies to multi-node products only.

Description of Command Function

Enables the failover feature on the StoreOnce appliance. It is a direct map to the command sequence

hardware enable failover (see “hardware enable failover” (page 31)). For the initial release,

this command will only enable failover for the entire appliance. In following releases, the command

will be updated to enable failover for give service sets.

Command Syntax

system enable failover

Command Authority

Administrator

Command Object Requirements

Not applicable – objects exist within this command.

Command Parameter Requirements

Not applicable – no parameters exist within this command.

Requirements for Command Execution

• The command entry must conform to the command syntax.

• Failover must already be disabled.

Successful Command Output

Upon successful completion of the command, the following is displayed:

failover enabled

Command Operation during Abnormal Conditions

• If the command does not conform to the required syntax, the following is displayed:

Command Failed - the command does not conform to the required syntax,

SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this

section.

• If failover is already enabled, the following is displayed:

Command Failed - failover is already enabled

Example

# system enable failover

failover enabled

110 Alphabetical List of Commands and Details

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 177 178

Brak uwag

HP D2D2502i Podręcznik Użytkownika Strona 110