HP D2D2502i Podręcznik Użytkownika Pobierz pdf (Strona 117)

4 (IEEE 802.3ad Dynamic Link Aggregation),

or 6 (Active Load Balancing),

(default = 1): 1

Enter 1GbE management network start IP address

(must be IPv4 X.X.X.X):

Enter 1GbE management network end IP address

(must be IPv4 X.X.X.X):

Enter 1GbE management subnet mask

(must be IPv4 X.X.X.X):

Select bonding mode for 1GbE data bond

enter 1 (Active/Backup),

4 (IEEE 802.3ad Dynamic Link Aggregation),

or 6 (Active Load Balancing),

(default = 1): 1

Enter 1GbE data network start IP address

(must be IPv4 X.X.X.X):

Enter 1GbE data network end IP address

(must be IPv4 X.X.X.X):

Enter 1GbE data subnet mask

(must be IPv4 X.X.X.X):

====================================================================

Template #5 - Management/Data/Replication on (2) 1Gb ports (bonded)

Do you want to configure a combined 1GbE management and data network? [Y/(N)]: y

Enter Virtual Management Console IP Address

(must be IPv4 X.X.X.X):

Select bonding mode for 1GbE management and data bond

enter 1 (Active/Backup),

4 (IEEE 802.3ad Dynamic Link Aggregation),

or 6 (Active Load Balancing),

(default = 1): 1

Enter 1GbE management and data network start IP address

(must be IPv4 X.X.X.X):

Enter 1GbE management and data network end IP address

(must be IPv4 X.X.X.X):

Enter 1GbE management and data subnet mask

(must be IPv4 X.X.X.X):

MENU Item 2

The following configuration steps will be performed:

Configure Network

-> Configure Time

Configure Licenses

Verify Hardware health

Configure Failover

Finish Configuration and reboot

Finish Configuration

Actions:

execute) Perform the current step (Default)

skip) Skip to the next step

back) Go back to a previous step

quit) Exit the configuration immediately

Configure Time [execute]?

Choose how to set time:

1) Set time explicitly

2) Set time using NTP server

skip) Skip setting time

Enter Selection: 1

Enter UTC time for the system (mm/dd/yyyy hh:mm:ss): 05/01/2013 09:39:00

Command Successful. The Backup System UTC has been set to 05/01/2013 09:39:00.

N.B. If set time is before current system time this warning will appear.

Current UTC : 05/01/2013 09:35:23

New UTC : 05/01/2013 09:35:05

Warning: System time will move backwards as a result of this command. The system will need to be rebooted via

the 'system reboot' command.

Enter 'y' to continue or 'n' to skip [default='n']:

system set config 117

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 177 178

Komentarze do niniejszej Instrukcji

Brak uwag

HP D2D2502i Podręcznik Użytkownika Strona 117

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Bramy / kontrolery HP D2D2502i