HP D2D2502i Podręcznik Użytkownika Pobierz pdf (Strona 64)

• domain – This optional parameter defines the domain name for the preceding subnet

configuration.

• IPAddr – This parameter defines an IP address. The value DHCP can be used to indicate that

the IP address will be defined by a DHCP server.

• netmask – This optional parameter defines the netmask. If the IPAddr value is DHCP, a value

is not required for netmask.

• gateway – This optional parameter defines the gateway for the subnet configuration.

• ports – This parameter defines the ports which will be attached to the subnet for each node

associated with the network configuration containing the subnet. (See the “net activate config”

(page 55) command for details on how the nodes are associated with network configurations.)

The values consist of a list of integers separated by commas; the integers define the physical

ports on the nodes. Execute the “net show ports” (page 78) command to obtain information

on which integers may be used to define ports for the subnet configuration. The maximum

number of values depends on your system; use the Command Authority (page 56) command

for information on which ports are available.

IMPORTANT: If a parameter is undefined in the modify command sequence, the current parameter

value remains unchanged.

If a parameter is given the value “undefined,” a value is no longer declared for the parameter.

Requirements for Command Execution

• The writeprotect parameter must be set to NO for this command to execute. (The writeprotect

parameter can be modified independent of the current state of the writeprotect parameter.)

• The command entry must conform to the command syntax.

• All object values must be valid; see the object descriptions for details.

• All parameter values must be valid; see the parameter descriptions for details.

Successful Command Output

Upon successful completion of the command, information on the external network configuration is

displayed.

Command Operation during Abnormal Conditions

If the command does not conform to the required syntax, the following is displayed:

Command Failed - the command does not conform to the required syntax,

SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this

section.

Example

# net modify config management dns 13.13.100.8

64 Alphabetical List of Commands and Details

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 177 178

Brak uwag

HP D2D2502i Podręcznik Użytkownika Strona 64