HP D2D2502i Podręcznik Użytkownika Pobierz pdf (Strona 39)

hardware set ports

NOTE: This command applies to single-node products only.

Description of Command Function

Sets the node’s physical port parameters.

Command Syntax

hardware set ports [NODEX] PORTX [speed {auto|2Gbs|4Gbs|8Gbs}]

[{Connection Loop|Fabric|pnt-to-pnt}]

Command Authority

Administrator

Command Object Requirements

• NODE

– This object defines the node containing the port whose parameters are to be set.

X is a numeric index for the node.

• PORT

– This object defines the port whose parameters are to be set. X is a numeric index

for the port.

Command Parameter Requirements

• Speed – This parameter defines the speed of the port. The possible values are defined in the

Command Syntax section.

• Connection — This parameter defines the connection type. The possible values are defined

in the Command Syntax section.

Requirements for Command Execution

• The command entry must conform to the command syntax.

• All object values must be valid; see the object descriptions for details.

• All parameter values must be valid; see the parameter descriptions for details.

Successful Command Output

Upon successful completion of the command, the following is displayed:

Command Successful

Command Operation during Abnormal Conditions

If any of the command execution requirements fail, command execution terminates. The node's

ports are unchanged and one of these error messages is displayed:

• Command Failed - the command does not conform to the required syntax,

SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this

section.

• Command Failed – The port is invalid

• Command Failed – The node is invalid

• Command Failed – Cannot change port settings on a node while in

failover

Example

# hardware set ports port1 speed 8Gbs

Command Successful

hardware set ports 39

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 177 178

Brak uwag

HP D2D2502i Podręcznik Użytkownika Strona 39