HP D2D2502i Podręcznik Użytkownika Pobierz pdf (Strona 80)

net validate config

NOTE: This command applies to single-node products only.

Description of Command Function

Validates a configuration. The command checks the data structure according to the rules listed in

the net activate config command. However, unlike the activate command, the external

network is not configured as defined by the data structure. This command exists to allow a newly

created configuration to be tested before configuration is actually activated. For example, if the

activation is scheduled to take place at a given time when the backup traffic is low, the command

provides confidence the net activate config command will execute successfully.

Command Syntax

net validate config <netlabel>

Command Authority

Administrator

Command Object Requirements

netlabel – This label identifies the network configuration object whose data structure will be used

to configure the external network for the cluster.

Command Parameter Requirements

Not applicable – no parameters exist within this command.

Requirements for Command Execution

The following list shows some examples but is not a complete list of checks. The system will verify

the configuration structure according to the rules below:

• A default subnet must exist.

• Only one default subnet can exists.

• A gateway is required for the default subnet.

• The ports defined in a subnets must be valid options.

• If more than one port is defined in a subnet, all the ports must be the same type.

• The same port cannot be in two different subnets or defined twice in same subnet.

• If IP addresses are defined, the netmask and gateway must be valid.

• If IP addresses are defined, the range for each subnet must be unique.

• If an IP address list exists, it must be large enough for all nodes in the cluster.

• If Data VIFs are defined, they must all be valid in the IP address structure.

• If Data VIFs are defined, the range for each subnet must be unique.

• If a Cluster VIF is defined, it can only be defined on one subnet.

Successful Command Output

Upon successful completion of the command, information on the external network configuration is

displayed.

Command Operation during Abnormal Conditions

If the command fails, the system will attempt to configure the external network using the original,

current configuration.

Example

# net validate config management

80 Alphabetical List of Commands and Details

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 177 178

Brak uwag

HP D2D2502i Podręcznik Użytkownika Strona 80