HP D2D2502i Podręcznik Użytkownika Pobierz pdf (Strona 130)

time add ntpserver

Description of Command Function

Adds a network time protocol server to use if ntp is enabled. Up to two ntp servers may be defined

for the StoreOnce appliance.

Command Syntax

time add ntpserver {<FQDN>|<IPv4>} [{<FQDN>|<IPv4>}]

Command Authority

Administrator

Command Object Requirements

Not applicable – no objects exist within this command.

Command Parameter Requirements

ntp server ID – At least one ntp server ID must appear in the command entry. This parameter

appears after time add ntpserver and consists of either a fully qualified domain name (FQDN)

or an IPv4 address in the xx.xx.xx.xx format. Depending on the number of ntp server objects which

currently exist for the StoreOnce appliance, up to two ntp server ID parameters may exist within

the command entry. (No more than two ntp server objects can exist for a given StoreOnce

appliance.)

Requirements for Command Execution

• The command entry must conform to the command syntax.

• The ntp server ID must be for a valid ntp server on the StoreOnce management network.

• The number of existing ntp server objects within the StoreOnce appliance and ntp server ID

parameters defined within the command entry must be three or less.

Successful Command Output

Upon successful completion of the command, the following is displayed:

ntp server(s) added successfully

Command Operation during Abnormal Conditions

• If the command does not conform to the required syntax, the following is displayed:

Command Failed - the command does not conform to the required syntax,

SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this

section.

• If an ntp server ID does not exist on the network, the following is displayed:

Command Failed - NTPSERVER-ID does not exist, where NTPSERVER-ID is the

invalid ntp server ID parameter defined within the command entry.

• If the number of existing ntp server objects with the StoreOnce appliance and the time server

parameters defined within the command entry exceeds two, the following is displayed:

Command Failed – a maximum of three ntp servers may be assigned to

the D2D appliance

Example

# time add ntpserver ntp.hp.net

ntp server(s) added successfully

# time add ntpserver 10.10.10.10

ntp server(s) added successfully

# time add ntpserver 10.10.10.10 10.10.10.11

130 Alphabetical List of Commands and Details

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 177 178

Komentarze do niniejszej Instrukcji

Brak uwag

HP D2D2502i Podręcznik Użytkownika Strona 130

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Bramy / kontrolery HP D2D2502i