HP D2D2502i Podręcznik Użytkownika Pobierz pdf (Strona 59)

net create config

NOTE: This command applies to single-node products only.

Description of Command Function

Creates a data structure that defines a network configuration. (A default data structure exists as

part of the initial installation.)

Command Syntax

net create config <netlabel> [description <string>] [WriteProtect

{Yes|No}] [DNS {IPaddr|DHCP} [subnet <label>] [default {yes|no}] [domain

{<string> | DHCP}] IPAddr {DHCP|IP address} [netmask <mask>] [gateway

Command Authority

Administrator

Command Object Requirements

netlabel – This value is the label which identifies the network configuration that will be created by

execution of this command. The identified object is a data structure which defines a network

configuration. The label must uniquely identify the network configuration. It cannot be “ALL,”

“undelete,” or cannot begin with the letters “grp.” If the network label is “ALL,” “undelete,” begins

with “grp,” or is already being used to identify a network configuration, an error message will be

generated and the execution of the command will fail. This label is case insensitive.

• current – This is the network configuration with is currently being used to configure the entire

cluster or a group of nodes. If the cluster consists of groups of nodes, a current network

configuration can exist for each group.

• Factory_Default_Configuration – This is a network configuration object that is pre-defined at

the initial installation. This default configuration will be different depending on the StoreOnce

system.

Command Parameter Requirements

• description – This optional parameter describes the network configuration and is contained

in quotes (”). There is no limit to the number of characters.

• WriteProtect – This optional parameter determines if the network configuration can be modified.

The values for this parameter can be Yes or No. Yes means the network configuration cannot

be modified (with one exception – the WriteProtect parameter can be modified). If this

parameter is not defined in the command sequence, the default value is No. (The DEFAULT

configuration cannot be modified. The WriteProtect parameter of the DEFAULT configuration

is always Yes. The WriteProtect parameter of the DEFAULT configuration cannot be modified.)

• DNS – This optional parameter defines the DNS servers used in the network configuration.

The value can be an up to three IP address or the text DHCP. The value DHCP indicates the

DNS servers will be defined by the DHCP server. If more than one value is defined, the values

are separated by commas.

• default – This optional parameter must follow a subnet object within the command sequence.

This parameter defines if the preceding subnet configuration is the default subnet. The values

for this parameter can be either Yes or No. If a subnet label is defined and this parameter is

not defined following the subnet label, the default value for the subnet is No.

• domain – This optional parameter defines the domain name for the preceding subnet

configuration.

• IPAddr – This parameter defines an IP address. The value DHCP can be used to indicate that

the IP address will be defined by a DHCP server.

net create config 59

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 177 178

Komentarze do niniejszej Instrukcji

Brak uwag

HP D2D2502i Podręcznik Użytkownika Strona 59

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Bramy / kontrolery HP D2D2502i